50W Vpark Box MOD. With new TC solution, it can avoid dry heating.

$49.00 USD

Availability: In Stock

50W Vpark TC50 VT/VW Box MOD   Product introduction 50W Vpark TC50 VT/VW Box MOD, it's designed in California with latest Temp control function. Also with new TC solution, it......

Ecigar


Price Drop Alert

50W Vpark TC50 VT/VW Box MOD

 

Product introduction

50W Vpark TC50 VT/VW Box MOD, it's designed in California with latest Temp control function. Also with new TC solution, it can avoid dry heating and supply reliable performance.

 

Parameters

Battery size: 22*41*91mm
Wattage output: 1-50W
Temperature range:  200~600 F or 95~315℃

Output Voltage range: 2.2-4.2V

Battery Type: 18650 (20-35A)

Resistance range: 0.1 - 1.0 ohm(Ni200 coil) & 0.16 - 2.0ohm(in wattage setting)

Thread: Spring-loaded 510 Thread.

 

It comes with

  • 1 x 50W Vpark TC50 VT/VW Box Mod
  • 1 x USB cable
  • 1 x User Manual

Simple packing. Customary Packing from the factory, the packing is subject to change without notice.

 

Features

1. Aluminum alloy body

2. 4 Modes in One Wheel: TC/Wattage/On/Off

3. Under voltage protection

4. Low resistance protection

5. Reverse battery protection

6. Output short circuit protection

7. High temperature protection

 


 


 

Battery Installation: Open the package, take out Vpark Box TC50, click 'Clamshell battery cover buckle' to open the battery cover, and put the battery into compartment in the right position and negative directions.

Active on & off Switch: In shutdown mode, turn mode switch wheel to 'ON', 'W'or 'F' any mode of these, begin starting up. 3 seconds after turning mode switch wheel to 'OFF', begin shutdown mode, and screen is shut, entering to minimum power consumption status.

Automatic Screen Off: Without any operation after a minute, the screen will automatically shut down, press any key can wake up screen, entering standby interface.

Wattage Adjustment: Turn 'Mode Switch Wheel' to 'W' and gets into Wattage Adjustment Mode. The word 'watt' on screen can be chosen, and you can use Up&Down dial hold down left or right to adjust wattage.

Temperature Adjustment: Turn 'Mode Switch Wheel' to 'F' and gets into temperature adjustment mode. The word 'temp' on screen can be chosen, and you can hold down Up&Down dial left or right to adjust temperature.

 

 

Over-Temperature Protection: When the LCD reads 'TOO HOT' means that the sensor on RY102 board detected temperature is too high, will automatically power down to 25W output. When it tests the board temperature below the alert value, can return to normal output.

 

 

 

 

We Also Recommend