EHPRO BOX MOD and Nano Tank Full Kit
Availability: In Stock
EHPRO eKits G3 Kit (SPD A8 TC MOD + Billow V2 Nano Tank) Guarantee: 3 months for battery Product Introduction EHPRO eKits G3 Kit with SPD A8 TC MOD and Billow V2......
EHPRO eKits G3 Kit (SPD A8 TC MOD + Billow V2 Nano Tank)
Guarantee: 3 months for battery
EHPRO eKits G3 Kit with SPD A8 TC MOD and Billow V2 Nano Tank, is the newest and advanced MOD kit with 3 modes, TC/VW/VV mode. With 4000mAh battery capacity, silky and soft surface craft, and a 3ml RTA tank, it will be a prefect combination for you.
SPD A8 Battery:
Size (length x width x height): 89 x 22 x 55mm
Variable Wattage: 5W - 80W
Variable Voltage: 0.5V - 8V
Variable Temperature: 200℉ - 600℉
Resistance range: 0.1ohm - 3.0ohm
Colors if SPD A8: black, blue, green, red, white
Billow V2 Nano:
Size (diameter x lenth): 22mm x 57mm (not including 510 thread)
EHPRO eKits G3 Kit comes with
- 1 x 80W EHPRO SPD A8 MOD
- 1 x EHPRO Billow V2 Nano
- 1 X Micro USB Cable
- 1 x User Manual
Simple packing. Customary packing from the factory, the packing is subject to change without notice.
1. Temperature Control, 3 modes TC/VW/VV Modes Available
2. Support Wattage Upgrading to 120W
3. Human Engineering Principle Design
4. Perfect Combination of 4000mAh + 3ml RTA
Turn on/off: press power button 5 times within 2s will enable or disable SPD A8.
Vaping: while it's turned on, and connected to a pre-filled tank, press power button to start vaping. It has 10s cut off time and will stop work after you vape it for continuous 10s.
TC/VW/VV mode switch: press power button and "+" or "-" to enter function setting interface. Press "+" button to scroll through the options or press "-" to return to the previous menu.To choose a desired menu, press power button. There are Temperature Ni and Temperature Ti mode to choose under the TC mode.
Temperature Units Switch: it supports both Celsius or Fahrenheit. After entering "temperature system" menu, press "+" button to scroll through and power button to confirm.
Hand Mode Setting: enter "Hand Mode Setting". Then press "+" button to check through options and press power button to choose the mode you prefer.
Display Mode Setting: SPD A8 has "STEALth MODE", which is much like power saving feature and "NORMAL MODE". To change this, just enter "Display Mode Setting".
TC Power Limit Setting: the default setting is 50W in this device. Please do not exceed the prescribed value to avoid any "dry hits". To change TC power, just go to the TC Power Limit Setting menu.
System Software Updating: system software can be upgraded via the Micro USB cable. Enter into the System Software Updating menu, press power button and it is in the state of waiting for promotion.
How to fill Billow V2 Nano: take the bottom hardware and the chimney part apart; tilt the chimney part and keep the filling hole upwards. Then start to fill the oil; screw the chimney part onto the bottom hardware after filling. Make sure they are tightly connected.
Notice: the filling hole must be upward when filling, to avoid overflow; do not fill liquid into the chimney.
It comes with spring-loaded 510 thread, compatible with most 510 thread cartomizers.