SMOK TFV4 Mini Tank Kit - 3.5ml Black
Availability: In Stock
SMOK TFV4 Mini Tank Kit - 3.5ml, Black Product Introduction SMOK TFV4 Mini Tank Kit - 3.5ml, Black, is a compact tank from SMOK. With 22 mm in diameter,......
SMOK TFV4 Mini Tank Kit - 3.5ml, Black
SMOK TFV4 Mini Tank Kit - 3.5ml, Black, is a compact tank from SMOK. With 22 mm in diameter, this mini tank matches a wide range of mods. It is designed to bring you unexpected vaping experience.
Size (height x diameter): 73.5mm x 22mm
Material: Glass & Stainless Steel
It comes with
- 1 x TFV4 Mini Tank (with TF-CLP2 coil 0.35ohm)
- 1 x TF-S6 coil head 0.4ohm(30W-100W)
- 1 x TF-RCA coil head
- 1 x Mini TFV4 glass tube
- 1 x Black sealing pad A
- 1 x Black sealing pad B
- 2 x Top Cap sealing pad
- 1 x Small airflow tip
1 x Airflow slot sealing ring
- 1 x Black silicone band
- 1 x Red silicone band
- 2 x Drip tip O-ring
- 1 x Screwdriver
- 1 x Japanese cotton
- 1 x Heating coil
- 1 x Airflow tube O-ring
- 1 x Indicator card for filling e-liquid
Simple packing. Customary packing from the factory, the packing is subject to change without notice.
More compact design
Special clapton core
Temperature sensing coils
Separate chamber design
Double-layered Heat Insulation Drip Tip
100% Organic Cotton
How to fill e-liquid:
Hold your tank with one hand, and use another one to press top cap and move it counterclockwise;
add e-liquid through the slot, and pay attention not to drip it into the central airflow tube;
lastly, close the cap carefully and firmly. Then let it wait for several minutes to get the organic cotton completely saturated.
How to build the RBA:
Firstly, please make sure your hands are clean;
take RBA apart;
install and position the pre-wrapped coil: place the coil between the posts and wrap the ends around the screws and tighten up, make sure the coil is fined in the center and lined up with the air hole and also make sure the coil is not touching the base;
cutting the ends of wire off;
cut a strip of cotton and make sure it's not too much or too less;
insert the cotton, and placing it in the middle;
cutting the cotton at an angle and make sure it's not too short or too long;
wet the coil with your liquid and adjust the cotton.
- It comes with 510 thread.